801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 • www.sdcsecurity.com • E-mail:
[email protected]
1591U EMLOCK® INSTALLATION INSTRUCTIONS 1.
Prepare door jamb for EMLock per template drawing.
2.
Locate reinforcement plate and mounting tabs as shown.
3.
Center Armature Plate to the centerline of the lock. The cutout for the armature must be 1-1/2” wide and 6-1/2” long.
4.
Install an armature reinforcement plate or the Amp mounting plate so that there is a 5/8” pocket when measured from the leading edge of the door. The AMP mounting plate is used to reinforce the mortise cutout in a wood door. It is secured to the door with four (4) #10 wood screws and then the EMLock armature is secured to the mounting plate with a 5/16”-18 x 3/4” bolt.
NOTE: The AMP mounting plate is an option available from SDC. 5.
Attach the EMLock wire leads to the power source and then install the EMLock and the armature with screws provided.
SYSTEM WIRING ACCESS, EGRESS AND REMOTE CONTROLS
+ TO 24VDC (+/-10%) FUSED, REGULATED & FILTERED POWER SOURCE
(+) RED/BLK
RED
ELECTRONICS -
(-) WHT/BLK
RED
(+) RED/BLK
RED
RED BLK ORG WHT
24V CONFIGURATION
RED ORG BLK WHT
12V CONFIGURATION
ACCESS, EGRESS AND REMOTE CONTROLS
+ TO 12VDC (+/-10%) FUSED, REGULATED & FILTERED POWER SOURCE
ELECTRONICS -
RED
(-) WHT/BLK 1591U – DPS OPTION N/C ORG
COM
N/O
YEL GRY
(POLARITY SHOWN WITH THE DOOR OPEN)
IMPORTANT WIRING INFORMATION:
Use the system wiring diagram to configure the EMLock for 12 VDC or 24 VDC operation. Although using a DC power supply is recommended, a transformer with a bridge rectifier may also be used as a DC power source. If you are using a transformer and rectifier, a transformer with the correct output voltage must be used. Access controls must not be wired to the AC side of the bridge rectifier or power supply. Access controls must always be wired to break the DC side of the power source. P:\INSTALLATION INST\Electromagnetic Locks\INST-1591U.vsd
REV C
01-17
Page 1
1.000 1.470
FRAME OR SLIDING DOOR
OUTLINE DIMESIONS
WIRE EXIT EITHER END DOOR CUTOUT
FRAME
DOOR
1.48 WIDE
.125
1.500 CL
.180
.500
1.000
.180
1.500
2.750
2.250
1.000 6.310
11.125
CL
6.500 1.000
5/16-18 TAP THRU
2.250
2.750
.250 DIA 2 PLACES .312
DRILL FOR #10-1 SCREW 4 PLACES
.750
1591 EMLOCK
10.030
9.250
10.000
8.000
REINFORCING
REINFORCING OR AMP MOUNTING PLATE
ARMATURE
1.485 WIDE
.680 .250
2 RUBBER WASHERS
1.025
1.025 .125
5/16 x 8 SCREW
OUTLINE DIMENSIONS
ARMATURE
REINFORCEMENT
1.750
SPACER
FRAME CUTOUT
1 STEEL WASHER
DOOR AND FRAME PREPARATION 1591U EMLOCK®
P:\INSTALLATION INST\Electromagnetic Locks\INST-1591U.vsd
REV B
01-17
Page 2
9.250
11.125
